Difference between revisions of "ArteryTek AT32F43x"
(→Internal Flash) |
(→Device Specific Handling) |
||
| Line 31: | Line 31: | ||
==Device Specific Handling== |
==Device Specific Handling== |
||
| + | ===Connect=== |
||
| + | *On Connect, protection level is checked. For further information regarding this, please click [[ArteryTek_AT32| here]]. |
||
| + | |||
===Reset=== |
===Reset=== |
||
*The device uses normal Cortex-M reset, no special handling necessary, like described [[J-Link_Reset_Strategies#Type_0:_Normal | here]]. |
*The device uses normal Cortex-M reset, no special handling necessary, like described [[J-Link_Reset_Strategies#Type_0:_Normal | here]]. |
||
Revision as of 10:18, 16 March 2024
ArteryTek AT32F43x are Cortex-M4 based MCUs
Contents
Flash Banks
Internal Flash
| Flash Bank | Base address | Size | J-Link Support |
|---|---|---|---|
| Internal flash | 0x08000000 | Up to 4096 KB | 
|
| User data | 0x1FFFC000 | up to 4 KB |
|
QSPI Flash
QSPI flash programming requires special handling compared to internal flash. For more information about this, please see the QSPI Flash Programming Support article.
J-Link supports multiple pin configurations for AT32F43x. The default loader is marked in bold.
| Device | Base address | Maximum size | Supported pin configuration |
|---|---|---|---|
| QSPI1 AT32F435 |
0x90000000 | Up to 64 MB |
|
Watchdog Handling
- The watchdog is fed during flash programming.
Device Specific Handling
Connect
- On Connect, protection level is checked. For further information regarding this, please click here.
Reset
- The device uses normal Cortex-M reset, no special handling necessary, like described here.
