Difference between revisions of "NXP MCXN10"
(→Attach) |
|||
| Line 40: | Line 40: | ||
====Attach==== |
====Attach==== |
||
| − | *Attach is NOT supported for |
+ | *Attach is NOT supported for MCXN547 & MCXN947, because the J-Link initializes RAM by default. |
*For all other devices attach is supported. |
*For all other devices attach is supported. |
||
Revision as of 10:50, 22 May 2023
Contents
The NXP MCXN10 are dual core Arm Cortex-M33 microprocessors.
Flash Banks
Internal Flash
| Flash Bank | Base address | Size | J-Link Support |
|---|---|---|---|
| Main flash (NS) | 0x00000000 | Up to 2 MB | 
|
| Main flash (S) | 0x10000000 | Up to 2 MB |
|
QSPI Flash
QSPI flash programming requires special handling compared to internal flash. For more information about this, please see the QSPI Flash Programming Support article.
J-Link supports multiple pin configurations for [DEVICE]. The default loader is marked in bold.
| Device | Base address | Maximum size | Supported pin configuration |
|---|---|---|---|
| QSPI flash (NS) | 0x80000000 | 256 MB | *Default CS@P3.0 SCLK@P3.7 D0@P3.8 D1@P3.9 D2@P3.10 D3@P3.11 |
| QSPI flash (S) | 0x90000000 | 256 MB | *Default CS@P3.0 SCLK@P3.7 D0@P3.8 D1@P3.9 D2@P3.10 D3@P3.11 |
ECC RAM
- Device has ECC RAM.
- A connect to devices MCXN547 & MCXN947 will initialize 64KB at 0x20000000.
Multi-Core Support
Before proceeding with this article, please check out the generic article regarding Multi-Core debugging here.
In below, the debug related multi-core behavior of the J-Link is described for each core:
Main core CPU0(CM33)
Init/Setup
- Initializes the ECC RAM for devices MCXN547 & MCXN947.
- Enables debugging
Reset
- Device specific reset is performed.
Attach
- Attach is NOT supported for MCXN547 & MCXN947, because the J-Link initializes RAM by default.
- For all other devices attach is supported.
Secondary core CPU1(MICR-CM33)
Init/Setup
- If the main core session has not been started / debugging is not enabled yet, the secondary core executes the enable debug sequence.
- If the secondary core is not enabled yet, it will be enabled / release from reset.
Reset
- No reset is performed, but will halt the CPU.
Attach
- Attach is supported
Device Specific Handling
Reset
The J-Link performs a device specific reset sequence. The reset is executed for the main core, only. Reset of the main core, resets / disables the secondary core if used in parallel.
Evaluation Boards
- NXP MCX-N9XX-EVK evaluation board: https://wiki.segger.local/NXP_MCX-N9XX-EVK
Example Application
- NXP MCX-N9XX-EVK evaluation board: https://wiki.segger.local/NXP_MCX-N9XX-EVK#Example_Project
