Difference between revisions of "SparkFun MicroMod RP2040"
(→Samples) |
|||
Line 23: | Line 23: | ||
* [https://www.segger.com/products/development-tools/embedded-studio/ SEGGER Embedded Studio] V5.42a or later |
* [https://www.segger.com/products/development-tools/embedded-studio/ SEGGER Embedded Studio] V5.42a or later |
||
− | === |
+ | === QSPI Projects === |
* [[Media:sparkfun_MicroMod_RP2040_blinky.zip | QSPI blinky]] |
* [[Media:sparkfun_MicroMod_RP2040_blinky.zip | QSPI blinky]] |
Latest revision as of 16:52, 23 April 2021
The SparkFun MicroMod RP2040 is a Raspberry Pi RP2040 evaluation board.
Features (selection)
- RP2040 MCU
- 16MB on board QSPI flash
- USB-C
- On board LED
- 30 I/O pins
- Cortex-M 9-Pin external debug connector
For further information please refer to the SparkFun MicroMod RP2040 web page.
Setting up with J-Link
The SparkFun MicroMod RP2040 can be placed on a SparkFun MicroMod ATP Carrier Board.
This carrier board comes with a Cortex-M 9-pin debug header
Note: For a all J-Link models, the SEGGER Cortex-M 9-Pin Adapter can be used for the SparkFun MicroMod ATP Carrier Board (except for J-Link EDU mini, which comes with a Cortex-M 9-Pin debug interface itself).
Example Projects
To run the following example projects the following prerequisites need to be met:
- J-Link software V7.00b or later
- J-Link HW revision 11 or later (J-Link EDU Mini and J-Trace Pro V1 or later also supported)
- SEGGER Embedded Studio V5.42a or later