Difference between revisions of "Main Page"
(→Troubleshooting) |
|||
| Line 7: | Line 7: | ||
==== Troubleshooting ==== |
==== Troubleshooting ==== |
||
| − | *[[Debug session does not start]] |
+ | * [[Debug session does not start]] |
| − | *[[J-Link can't connect to the CPU]] |
+ | * [[J-Link can't connect to the CPU]] |
| − | *[[J-Link-OB SAM3U]] |
+ | * [[J-Link-OB SAM3U]] |
| − | *[[J-Link-OB-RX621-ARM-SWD]] |
+ | * [[J-Link-OB-RX621-ARM-SWD]] |
| − | *[[SPI Flash]] |
+ | * [[SPI Flash]] |
==== Device specifics ==== |
==== Device specifics ==== |
||
Revision as of 18:57, 23 May 2016
Welcome to the SEGGER - Support Wiki
Debug Probes - J-Link & J-Trace
J-Link
Troubleshooting
- Debug session does not start
- J-Link can't connect to the CPU
- J-Link-OB SAM3U
- J-Link-OB-RX621-ARM-SWD
- SPI Flash
Device specifics
Freescale
- FlexNVM partitioning
- i.MX6 SoloX Support
- Reset on Kinetis devices
- Secured Kinetis device detected
- Writing to Program Once Field
- EzPort disables debug interface
NXP
Renesas
ST
- Connecting to STM32 Nucleo boards
- Using SWO on STM327xxG evaluation boards
- Setting read out protection on STM32F0 devices
- Secured ST device detected
- STM32L4 dualbank flash programming
